Facts About Container Chassis Revealed
Facts About Container Chassis Revealed
Blog Article
Heat therapy whole lot is the amount of casting within the exact same specification subjected to the identical warmth treatment method simultaneously.
The loaded container is to be effective at getting supported on the four positions in which provision has been designed for lifting tools.
Upon removal from the examination load from the vertical direction, the torque delivered with the enter shaft to extend or retract the leg shall not exceed 600 inchpounds.
Each individual container will be to be equipped with a minimum of just one indicating thermometer effective at withstanding more than the street shock and shipboard vibration. They are for being of a kind not afflicted by weather conditions or sea drinking water spray.
A coupling pin, generally referred to as a kingpin, is usually to be delivered for coupling the chassis towards the fifth wheel with the tractor. The situation of the kingpin is always to be specified because of the applicant. The dimensions on the kingpin are to get in accordance with ISO 337 as proven in Figure fifteen.
designs are to generally be submitted for evaluate of each and every container refrigeration machinery type to be certified. Prior to the particular commencement of your screening from the prototype device, the Surveyor is to acquire readily available strategies which delineate the arrangements and particulars in the prototype as designed.
. The more info container is to have two fork tines or equivalent inserted in to the pockets. The load software to the pocket floor by the fork tine is always to be uniformly distributed above an area two hundred mm (8 in.
Fork-elevate pockets could be delivered for dealing with containers from the loaded or unloaded condition. The fork-raise pockets are to satisfy the dimensional specifications laid out in Figure 6.
The overall dimensions of the container may well differ from the required dimensions in the tolerances revealed in Figure six.1. Tolerances for intermediate specified Proportions may be acquired by interpolation.
entrance and rear conclusion panels are to get capable of withstanding the racking imposed on The underside container in the stack in the event the containers are carried on deck beneath conditions affording constrained exterior racking restraint.
Fork-elevate pockets, when presented, are to become for handling the tank container only when empty and they are to become marked appropriately.
The chassis will be to be put on a level asphalt or concrete surface area. The landing equipment legs are to generally be prolonged to keep up the chassis inside of a stage situation. A container is to be put on the chassis and secured With all the chassis have container securing equipment. The container will be to be loaded with an evenly distributed load. the burden with the container with its load, additionally the chassis is always to equal the GVWR.
The tests outlined On this portion are to become carried out from the existence of a Surveyor within the prototype tank container which includes correctly finished the tests necessary by segment seven as applicable.
Report this page